What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 02:19

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
How can someone effectively handle a targeted individual?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
[old diagram got deleted by accident]
In schematic diagrams this is the symbol for a fuse:
Thousands of Netflix fans gather for Tudum - TechCrunch
Edit 2024–10.
These are simplified answers to the original question, and does not change anything I wrote above.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
9 Pro Comparisons for Top Prospects After the 2025 NHL Draft Combine - Bleacher Report
The bolt then partially travels down the line to your home.
Now when you have a certain ac resistance, then a current flows in a loop.
What is lightning?
How can a hacker damage me, realistically?
These devices are installed between the “hot” and “neutral” and protective ground.
At one ohm, the resistor has a maximum of 1 watt power.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
But it can get overloaded, and no longer works.
He then asserts :
An AC voltage/ current source, and an ac inductive load.
Those Ice Baths May Not Be 'a Great Idea' - Newser
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This one hit behind the barn.
Measles 'exposure event' confirmed in Great Falls - KRTV
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
At least they know the answer if they wanted it.
Dodgers To Designate Chuckie Robinson For Assignment - MLB Trade Rumors
2024–10–10[John johnson John Johnson ]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
but I think this circuit , shows a few more pieces.
This device then solves the entire problem.
There are three different concepts here that are getting confused.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
He then describes the function of a fuse.
(Dc diagram shown, AC is similar).
Portugal beat Spain on penalties to win Nations League - Yahoo Sports
Barnstars:
The other is “what does a “fuse” do?”
what exactly is a ‘surge’ protector?
Ending Parole for 500,000 Migrants Creates New Headaches for Employers - WSJ
A fuse is a non-resetable over current circuit protector.
What does a fuse do?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The third is lightning and “how it gets conducted into a home.”
I post the exact comment here.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–10–16 [ OO OLAOYE OYEBODE ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
He then describes Rainy Season and Lightning.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
[image of Common-mode choke]
For this case there are devices called Metal oxide varistors (MOV).
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is where this question deviates from being a 'generic' question, and becomes more specific.
Here is a simplified AC power diagram.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
The MOV will conduct when the voltage exceeds 50% of line voltage.
so, what happens?
Upvotes:
So, the voltage could go up to 500 volts, and the fuse will not open up.
the problem then depends on "how fast does the fuse operate?".
a photo is worth a thousand words.
One is “what exactly is in a ‘surge protector’ ? ”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
It also is a device that limits the change in current flow.
nine
This is where the MOV conducts again, and dissipated the energy.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
but this device (an Inductor) … impedes the rapid changes in the current.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
But… the neutral is now “floating” because of the 1 ohm resistance.
There are two important concepts here.
It seems Mohan does not understand the difference between a comment and an Answer.
One
A circuit breaker is similar, but is resettable.
eight
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
First Sentence:
This is 'the assistant's answer'